how pairs of nipple drinking threaded models

How to install tool drink (nipple drinker) chicken / poultry threaded models properly.

How to install tool drink / nipple drinker threaded models are not different from the way the installation of other types of nipple drinker, the following tools and materials required :



~ Drill hand.

~ drill of bolt size 14.

~ AW 1-inch PVC pipe.

~ Nipple threaded models wrapped in tape seal.

~ Abrasive.

Here's how to attach the tool to drink / nipple drinker for chicken threaded models are good and right.

1. Prepare a hand drill that can rotate to the left and to the right.

2. Create the drill bit from the bolt size "14" finely threaded, cut his head, is left 4 cm and ends digurinda formed into the drill.

3. AW 1 inch PVC pipe drilled slowly to the right, until the pipe wall forming hollow and threaded in.

4. After the hole, drill slowly withdrawn with a round drill be left behind.

5. Nipple threaded models that have been wrapped disposable seal tape (TBA) 7 times coil, mounted on PVC pipe hole. When the installation is less than perfect, threaded holes can be repeated and winding TBA increased to 10 coils .

Note :

1. the installation in this way, it will be permanently installed, do not leak, faster and cheaper cost.

2. if already installed all, tested flow energized, if there's a leak 2 or 3 seeds, can be removed nipplenya, winding TBA repeated becomes thicker and installed again until it does not leak.

3. No need to wear a saddle or a rubber seal, even if the rubber seals can leak into stiff.